Skip to main content
Migration Notice
We're migrating documentation from the old portal into this one. Some things may look a little different or out of place in the meantime — we know, and we're working to get it right. If something's unclear or doesn't look right, let us know.
Version: 2.10.1

Post Failover Steps

Introduction​

After executing any type of failover, there are certain steps which must be taken to ensure proper functioning of your Eyeglass VM and all associated Clusters.

Post-Failover Steps​

There are several procedures that may be followed after Failover to verify that everything is in its expected State and Location. To make sure you only encounter relevant information, we must separate these steps into sub-articles as follows:

IMPORTANT FOR ALL FAILOVER TYPES

If the Failover was done with the Controlled Failover box unchecked, then some steps on the Source Cluster will not have been executed.

info

In the articles linked above, the Source Cluster refers to the Cluster you Failed Over from, and the Target Cluster is where you Failed Over to.

See Also​

You may also take a look at our Failover Troubleshooting guide.